For a soak or pre->vash, Liquid bleach dispenser – Whirlpool LA609OXS User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
For a soak or pre->vash
For best results, use
warm
water
for soaking or pre-washing stained
laundry.
Hot water can set stains.
1. Use recommended amount of
detergent or pre-soak product.
2.
Push Control Knob in.
3.
Turn clockwise to point at a
number
in the SOAK Cycle. Use the 4 minute
mark for a pre-wash.*
4.
Pull Control Knob out. The washer
will start.
5.
When the cycle is over, add
detergent for the next selected
wash cycle.
The SOAK Cycle
should always be followed by a
Wash Cycle.
important: See additional care
Information in your “Laundry
Guide.”
*To start soak or pre-wash with agitation, the Control Knob
must point to a number in the SOAK Cycle.
Liquid bleach dispenser
Always measure bleach. Do not
guess. Never use more than 1 cup
(250 mL) for a full load.
Use less with
lower water level settings. Follow
directions on bottle for safe use. Use
a cup with a pouring spout to avoid
spilling.
1.
Load the washer first.
2.
Pour
measured
bleach carefully
into dispenser.
DO NOT
let bleach
splash, drip or run down into the
washer basket.
Undiluted bleach
will damage any fabric it touches.
3.
Start the washer. Bleach will be
diluted automatically during the
wash part of the cycle.
For more information on bleaching, see your “Laundry Guide.”
13