Whirlpool FGS395V - Manual (Page 14)

Before You Call For Service
If you are having an operating problem,
check the chart to see what the cause
might be before you call for assistance.
OPERATING PROBLEM CHECK IF WHAT TO DO
Nothing operates. ■ Range is properly connected to gas ■ Reconnect range to gas and/or electrical
and electrical supplies. supplies. (See Installation Instructions.)
■Fuse has blown or circuit breaker has ■Replace fuse or reset circuit breaker. In case
tripped. of prolonged power failure, manually light
burners (see page 4).
■ Control knob is set in the correct
position.
■Set control knob correctly, if needed.
■ The flow of combustion and /or venti- ■ Remove blockage to air flow to and around
lation air to the range is blocked. range.
Oven will not operate. ■ The electronic controls are set cor­
rectly. See pages 4-7.
■You have programmed a delay start
time.
■Reset controls, if necessary.
Burner fails to light. ■ Range is connected to electrical ■Reconnect range to electrical supply. (See
power. Installation Instructions.)
■ Fuse has blown or circuit breaker has ■Replace fuse or reset circuit breaker. In case
tripped. of prolonged power failure, manually light
burners (see page 4).
■ Burner ports are clogged. ■ Clean with a straight pin (see pages 9 and 12).
Burner flames are uneven. ■Burner ports are clogged. ■ Clean with a straight pin (see pages 9 and 12).
If this fails, call an authorized Roper™ service
technician for service.
Burner flames lift off ports, ■ Contact an authorized Roper™ service
are yellow, or are noisy
when turned off.
technician to check air/gas mixture.
Burner makes popping noise
when on.
■ Burner is wet from washing. ■ Let dry.
Continued on next page
Page 14