Before using your refrigerator, Removing packaging materials, Cleaning it before use – Whirlpool 4ET14GK User Manual
Page 5: Cleaning your refrigerator, Plugging it in
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BEFORE USING YOUR REFRIGERATOR
Before Using Your
Refrigerator
In This Section
Page
Page
Cleaning your refrigerator........ ............5
Installing it properly............. ................. 6
Plugging it in.............................. ............5
Leveling it............................. ................. 6
It is important to prepare your refrigerator for use. This section tells you how to clean it,
connect it to a power source, install it and level it.
Cleaning your refrigerator
Removing packaging materials
Remove tape and any inside labels (except
the model and serial number label) before
using the refrigerator.
To remove any remaining glue:
• Rub briskly with your thumb to make a ball,
then remove.
OR
• Soak area with liquid hand-dishwashing
detergent before removing glue as
described above. Do not use sharp
instruments, rubbing alcohol, flammable
fluids or abrasive cleaners. These can
damage the material. See “Important
Safety Instructions” on page 3.
NOTE: Do not remove any permanent
instruction labels inside your refrigerator. Do
not remove the Tech Sheet fastened under
the refrigerator at the front.
Cleaning it before use
After removing all packaging materials,
clean your refrigerator before using it, if
necessary. See cleaning instructions on
pages 12 and 13.
Plugging it in
Recommended Grounding Method
A 220 Volt, 60 Hz., AC only 15 or 20 ampere
fused and properly grounded electrical
supply is required. It is recommended that a
separate circuit serving only this appliance
be provided. Use a receptacle which cannot
be turned off with a switch or pull chain. Do
not use an extension cord.