Other operating instructions, For a soak or pre-wash – Whirlpool LA6300XP User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Other operating instructions
You may need an extra rinse and
spin for heavily soiled loads which
need more detergent (Extra de
tergent can require an extra rinse.)
• Push Control Knob in
• Turn clockwise to any • on the dial
See above drawing.
• Pull Control Knob out
• The washer will fill to selected
level; agitate 2 minutes; drain
and spin.
Your washer can be set to drain
and spin out water
• Push Control Knob in
• Turn clockwise to the bar |ust before
OFF in any cycle See above
drawing.
• Pull Control Knob out
• The washer will drain and spin.
For agitation and spin speeds in each cycle, see pages 6 -9.
For a soak or pre-wash
For best results, use warm water
for soaking or pre-washing stained
aundry Hot water can set stains.
• Use recommended dmount of
detergent or pre-sook product
• Push Control Knob in,
• Turn clockwise to point at
a
number
in the SOAK Cycle...use the 6-minutes
mark for a pre-wash.*
• Pull Control Knob out to start washer,
• When the cycle Is over, add de
tergent for the next selected wash
cycle The SOAK Cycle should
always be followed by
a
Wash
Cycle.
• Set the washer and start the next
selected wash cycle.
Important: See additional care intormatlon on page 7 of your
“Laundry Guide.”
■ To start soak or pre-wash with agitation, the Cycle Control Knob must point to
a number in the SOAK Cycle, as indicated by the arrows.
10