Whirlpool LE5200XT - Manual (Page 13)

Remove saews
Drum
Mal
Side panel
i
view B
VIewD
If your dryer I» ga« and has a full front
pviel, remove front panel as follows:
1. Unplug the power supply cord or turn
off the electrical power.
2. Open lint screen lid. Remove two
screws in lint screen area.
3. Open top by pulling forward and up
at each front corner (see view A).
Rest raised top against wall behind
dryer (top is hinged at rear).
4
.
Remove two internal screws from
front panel flanges (near top front
comers). Lift front panel slightly,
lifting off lower clips (see view B).
Slowly pull front panel forward,
disengaging panel from drum.
(Drum will drop slightly.)
5. Move front panel aside and rest edge
against side of dryer. Avoid discon­
necting wire dips (see view C) or
damaging wires.
6. Remove lint from area shown in 'gas
dryer* iilustration on page 12 with soft
brush or vacuum deaner. Avoid
damaging wires, funnel or igniter.
7. Reassemble in reverse order. Before
closing the top, check the following:
- Drum seal must be flared out (see
view D) and properly positiontfo
against panel at ba<^ of drum.
Rotate drum counterclockwise one
full turn to check drum seal.
- Belt should be centered and tight
on dryer drum.
- Wire dips which hold the door
switch wires must be anchored in
slot in top of front panel (see
view C) and along top edge of side
panel. Door wires must not touch
dmm when dryer is operating.
See Warning, page 12.
8. Replace top panel and lint screen
screws. Top and front panels must
be securely in place before operating
dryer.
9. Reconned power and level dryer
again (if necessary).
NOTE: Call Consumer Assistance at
1 -800-253-1301 for assistance or
more information.
13