Using spin only, Manual clean lint filter – Whirlpool LCR5232DQ0 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
O P E R A T I N G Y O U R W A S H E R
Using Spin Only
The Spin Only cycle helps shorten drying
times for some heavy fabrics or special-care
items by removing excess water.
1. Turn the Cycle Selector Knob to Spin
Only, as illustrated.
2. Push the Start/Pause button. The washer
drains for 4 minutes and then proceeds to
spin. .
on both models
Manual clean lint filter
Clean filter after every load.
1. To remove, grasp the top of the agitator
with both hands. Pull upward to remove
agitator cap. Lint filter is attached to the
end of the shaft.
2. Detach lint filter by pinching forked ends
of shaft together. Slide lint filter off shaft.
3. Wash or wipe the lint filter clean.
4. Slide filter back into place on shaft (open
end up). Snap into place.
5. Push lint filter and agitator cap firmly back
into agitator.
Lint filter
10