Using rinse and spin, Using drain and spin, Understanding normal washer sounds – Whirlpool 8LSR5233EZ0 User Manual
Page 9: During drain, During washing, After drain and before spin, Using rinse and spin using drain and spin
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATING YOUR WASHER
Using rinse and spin
NOTE: An Extra Rinse option is available in
all cycles. See page 6.
When using extra detergent for heavily soiled
clothes, or washing special-care items, you
may find an extra rinse and spin is needed.
1. To add an extra rinse, push in the Cycle
Control Knob and turn clockwise
to Rinse, as illustrated.
2. Pull out the Cycle Control Knob. The
washer fills to selected load size,
agitates, drains, and spins.
P. Press /
Wrinkle Resist
Using drain and spin
A drain and spin may help shorten drying
times for some heavy fabrics or special-care
items by removing excess water.
1. Push in the Cycle Control Knob and turn
clockwise to Spin, as illustrated.
2. Pull out the Cycle Control Knob. The
washer drains, then spins.
Heavy
P. Press /
Wrinkle Resist
Understanding normal washer sounds
During drain
The rate that water is drained from your
washer depends on your installation. If water
is drained quickly from the washer, you may
hear air being pulled through the pump. This
happens during the end of draining.
Your new washer may make sounds that
your old one didn’t. Because the sounds
are unfamiliar, you may be concerned about
them. Don’t be; most of them are normal.
The following describes some of the sounds
you may hear and what causes them.
During washing
When you select a small load size setting for
a small wash load, your washer has a lower
water level. With this lower water level, you
may hear a clicking sound from the upper
portion of the agitator.
After drain and before spin
When the cycle changes from draining to
spinning, you may hear gears engaging.