Soak cycle, Magic clean» lint filter, Liquid bleach dispenser – Whirlpool LA9looxT User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Soak cycle
For best results, use warm water for
soaking stained iaundry. Hot water can
set stains.
1. Use recommended amount of
pre-soak product or detergent.
2. Push Cycle Control Knob in.
3. Turn clockwise to point to a number
next to SOAK.
4.
Puli the Cycle Control Knob out.
The washer will start.
5. When the cycle is over, add
detergent for the next selected wash
cycle. The SOAK Cycle should
always be followed by a wash cycle.
NOTE:
See the Laundry Guide for
additional soaking information.
MAGIC CLEAN» lint filter
The lint filter in your washer cleans
itself. Collected lint is drained away with
the wash and rinse water.
If your washer drains into a tub,
remove any lint collected in the drain or
strainer.
Liquid bleach dispenser
Always measure bleach. Do not guess.
Never use more than 1 cup (250 mL) for
a full load. Use less with lower water
level settings. Follow directions on
bottle for safe use. Use a cup with a
pouring spout to avoid spilling.
1. Load the washer first.
2. Pour measured bleach carefully into
dispenser. Do not let bleach splash,
drip or run down into washer basket.
Undiluted bleach will damage any
fabric it touches.
3. Start the washer. Bleach will be
diluted automatically during the
wash part of the cycle.
11