Whirlpool 2184589 - Manual (Page 13)

U S I N G Y O U R R E F R I G E R A T O R
Attaching the ice maker to a water supply
Read all directions carefully before you begin.
AWARNING
Electrical Shock Hazard
Disconnect electrical supply to refrigerator
before installing.
Electrical drill must be grounded before
drilling holes in water line.
Failure to do so could result in death,
electricai shock, or serious injury.
IMPORTANT:
• Use copper tubing only and check for leaks.
• Install ice maker tubing in areas where temperatures
are above freezing.
Tools required:
• standard screwdriver
• yi6-inch and Vz-inch open-end wrenches or
two adjustable wrenches
• V4-inch nut driver
• V4-inch drill bit
• Hand drill or electric drill (properly grounded)
NOTE: Your appliance dealer has a kit available with
a V4-inch saddle type shut-off valve, a union, and
copper tubing. Before purchasing, make sure a saddle
type valve complies with your local plumbing codes.
Do not use piercing type or Yie-inch saddle valve
which reduces water flow and clogs more easily.
Cold water supply
The ice maker water valve contains a flow washer
which is used as a water pressure regulator. The ice
maker needs to be connected to a cold water line with
water pressure limitations of 20-120 psi. If a problem
occurs, call your utility company.
IMPORTANT:
• It may take up to 24 hours for your ice maker to
begin producing ice.
• If operating the refrigerator before installing the
water connection, turn ice maker to the OFF position
to prevent operation without water.
• All installations must be in accordance with local
plumbing code requirements.
INSTALLATION IS NOT WARRANTED
BY REFRIGERATOR OR ICE MAKER
MANUFACTURER.
Connecting to water line
1. Find a Vz-inch to 1V4-inch vertical COLD water pipe
near the refrigerator.
NOTE: Horizontal pipe will work, but the following
precaution must be taken: Drill on the top side of the
pipe, not the bottom. This will help keep water away
from the drill. This also keeps normal sediment from
collecting in the valve.
2. Measure from connection on rear of refrigerator to
water pipe. Add 7 feet (2.1 m) to allow for moving
refrigerator for cleaning. This is the length of ’/4-inch
O.D. copper tubing you will need for the job (length
from connection to water pipe PLUS 7 feet [2.1 m]).
Be sure both ends of copper tubing are cut square.
3. Turn OFF main water supply. Turn ON nearest
faucet long enough to clear line of water.
4. Using a grounded drill, drill a V4-inch hole on the cold
water pipe you have selected.
Vertical cold
water pipe
Packing
nut
Washer
Pipe clamp
'/4-inch O.D. copper
tubing (length from
inlet on rear of refrig­
erator to water pipe
plus 7 feet [2.1 m])
Water
shut-off
valve
Compression
sleeve
Compression
sleeve
Compression
nut
TO REFRIGERATOR -»
* Some models may not feature this second
compression nut and sleeve.
continued on next page
13