Whirlpool LMR4132B - Manual (Page 9)

O P E R A T I N G Y O U R W A S H E R
What happens in each cycle
When the Cycle Control Knob is set to a
number and pulled out, the washer fills to the
selected water level with the selected water
temperature before agitation and timing start.
The washer will begin agitating immediately
after filling; agitation can occur with the washer
lid up or down. After agitation starts, the knob
turns clockwise until it points to OFF and the
cycle ends.
The washer pauses briefly throughout
each cycle. These pauses are normal for
washer operation.
NOTE: If your washer drains into a laundry
tub, remove lint collected in the tub or strainer.
Fill
m
Wash selected time
Drain-No agitation
m
Spin
....
Fill
BH
Rinse
1:^1
Drain-No agitation
Spin
lAl
Off
Using the chlorine bleach dispenser
Always measure liquid chlorine bleach. Do not
guess. Never use more than 1 cup (250 mL) for
a full load. Use less with lower water level
settings. Follow manufacturer’s directions for
safe use. Use a cup with a pouring spout to
avoid spilling.
1. Load the washer.
2. Pour measured chlorine bleach carefully into
dispenser. Do not let bleach splash, drip or
run down into washer basket. Undiluted
bleach will damage any fabric it touches.
3. Start the washer. Bleach will be diluted
automatically during the wash part of the
cycle.
NOTE: Do not use this dispenser to add
powdered chlorine or all-fabric bleach to your
wash load. The dispenser is for liquid chlorine
bleach use only.