Whirlpool Thin Twin - Manual (Page 4)

I Insert a rear­
leveling leg into the hole in
the rear corner on the
bottom ot the
washer/dryer. Push leg in
until It snaps into place. Do
the same same thing with
the other leveling leg in
the other rear corner.
I Push up one leg;
check to see that the
other leg goes down.
Check the other leg the
same way. (If legs do not
adjust, repeat Step 4.)
^5 ■ With one of the front
legs in hand, check the ridges
for a diamond marking. That's
how far the leg is supposed
to go into the hole. Start to
screw the legs into the holes
in the front corners by hand.
Use slip-joint pliers to finish turning the front
legs until you reach the diamond mark.
Slide washer/dryer onto cardboard or
hardboard before moving across floor to
prevent damage to floor covering.
I Place a piece of
cardboard or
hardboard in front of
carton. Now stand the
washer/dryer upright.
Slide washer/dryer onto
cardboard or
hardboard.
To prevent product
damage, Do Not
remove corner
posts inside the
carton before
cutting.
8
I With the corner posts in
place, cut the carton down one corner.
Remove carton.
Numbers
correspond
to steps.
-1
[/'
9.
1'^
1
9
9.
Do Not
Remove
I Remove the two
rear corner posts located
at the back of fhe
washer/dryer. Remove
the two corner pieces
attached to the lower
front of the washer/dryer.
Do Not remove the foam
shipping pieces between
the washer and dryer until
the washer/dryer is in
place.
10
.
.rear
' --^corner
posts
12
I Remove yellow card. Take hoses
out of basket. Place hoses with other parts.
I Move
foam shipping
pieces outward just
enough to clear the
washer lid. Open
the washer lid. The
latch under the
dryer will hold lid
open.
Read yellow
card. '
Pull
all three
shipping
straps with
keys
completely
out of washer.
Do Not cut
shipping straps.
I Release washer
lid by pushing up on latch. Close lid.
Use new hoses and washers that came
with your washer/dryer.
I Read the yellow
card. Place hand on top of
agitator when removing the
shipping straps. Firmly jerk,
then pull the three shipping
straps up until each strap
with key is completely
removed from washer. Put
straps in the same area as
other shipping pieces.
Panel C
coupling washer
14
I Insert a large washer into each
end of the inlet hoses. Check that washers
are firmly seated in couplings.
Inlet valves are
plastic. Do Not
overtighten or
crossthread.
15
I Attach inlet hose to bottom
inlet valve opening first. Attach second inlet
hose to top inlet valve. Tighten couplings by
hand; then use piiers to make an additional
two-thirds turn. Do Not overtighten; this could
cause damage to coupling.
Numbers
correspond
to steps.