Cabletron Systems EMM-E6 - Manual (Page 20)

Using the EMM-E6 Hub View
2-4 Using the Hub View
Figure 2-2. EMM-E6 Hub View Device Menu
The Device menu lets you perform the following:
• Open the Device Status window
• Access the IP Address Table
• Open the Polling Intervals window
• Change the Port Display Form
• Launch the Global Find MAC Address Tool
• Start the Alarm Configuration application
• Start the Link/Seg Traps application
• Start the Repeater Redundancy application
• View the Source Address List
• Access the Security application
• Start the Front Panel Redundancy application
Note that the Device menu does not provide access to every application available
to the EMM-E6. Some information is only available from the Network, Module,
and/or Port menus, and several applications can only be accessed either from the
icon menu (if you are running under a network management platform) or from
the command line (if you are running in stand-alone mode). See Chapter 1,
Introduction
, for a complete list of applications available to the EMM-E6 and how
to access each one.