Cub Cadet 759-04080 - Manual

1
759-04080 CRUISE CONTROL KIT
Introduction
The cruise control kit is designed to allow the tractor op-
erator to maintain a desired “foot free” forward speed
in areas where constant speed changes are not re-
quired. The cruise control feature can only be operated
in the forward direction.
Installing the Cruise Control Kit
NOTE: Some installation procedures are more easily
performed from beneath the tractor. If equipped, the
mower deck may be removed from the tractor to im-
prove access.
Wire leads w/connectors needed to power the cruise
control magnet are provided in the tractor wire harness.
To install the cruise control kit, proceed as follows:
• Remove the plug from the right side of the dash
panel by sliding a thin flat edged tool beneath the
plug and prying upward. See Figure 1.
NOTE: The wire harness connector for the cruise switch
may be connected to the dash panel plug. If so, carefully
pull the wire harness connector up through the dash
panel while removing the plug. If the wire harness leads
are not connected to the plug, it will be necessary to re-
move the dash panel insert.
Figure 1
Remove
Plug
CUB CADET LLC P.O. BOX 361131 CLEVELAND, OHIO 44136-0019
PRINTED IN U.S.A. FORM NO. 769-01718 (3/05)
Installation Instructions
For Series 6000 Tractor Models
KIT COMPONENTS
1
2
3
5
4
6
1.
2.
3.
4.
5.
6. Special Screw
Magnet w/Spring Assy.
Cruise Latch Bracket
Hex Jam Nut, 7/16-20
Cable Tie
Cruise Switch 1750736
1768971
703-05791
712-0240
725-0157
725-04246
Ref. Pt. No. Description 7
7. 736-0171 Lock Washer, 7/16"