GE 52651 GE Fluorescent Closet Light 12 in User Manual

Ucjjj-j, 12“ cloiiil, Fluorescent

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Fluorescent

-12“ CLOiiil'

UcjjJ-J

Battery Operated

•Add safety and security to any room

Ideal for cupboards, closets, attics, basements,

storage sheds and garages

Reguires 8 AA"batteries

•For indoor use only

INSTALLING BAHERIES:

Slide battery cap off end of light and install 8 "AA", 1.5 volt

batteries (not included) with polarity as shown on diagram

on the fixture. Replace cap. IMPORTANT: Different types of

batteries or new and used batteries should not be mixed.
Exhausted batteries should be removed from the fixture

and disposed of properly.

MOUNTING:

Your closet light can be mounted

using the supplied adhesive-back

"hook and loop" mounting strips.

Note: "Hook and loop" strips

should only be used on clean,
dry, and smooth surfaces. Do
not use on unfinished wood or
rough surfaces.

1. Separate the supplied "hook

and loop" mounting strips

from each other, placing

the "hook" and "loop" sides
of the strips into two piles.

2. Clean and dry surface before

mounting. Peel back paper
and apply "loop" mounting

strips to both ends and middle

of the back of the closet light

1 »• »'

• O

»* «** *

t I * . *

3. Apply the "hook" strips to

the desired mounting location,

making sure they are the

same distance a part as

those on the closet light

4. Press the closet light onto

the mounting surface.

NOTE: Allow one day for the adhesive backing to set before

attempting to pull closet light away from mounting surface.

Light can also be mounted using supplied screws.

TUBE REPLACEMENT:

1. Remove end caps from light

2. Remove transparent lens cover.

3. Twist the tube slightly in either direction to remove.

4. Replace with 8-watt, 12" T5 bulb.

5. Replace tube cover and end caps.

CAUTION:

Do not turn on light with tube disconnected to avoid possible

damage to solid state circuit

imm-

<r

]

/

1

\

r

[J

■ -* ' '

A

WARNING

Batteries may leak harmful liquids
or ignitable materials or explode
causing injury or product damage

• Do not mix old and new or other

battery types

• Replace all batteries atthesame

time

• Replace fully discharged batteries

immediately

Advertising
Table of contents