Speed control panel, How to assemble and use – GE 106601 User Manual

Page 4

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

840079000 ENvOO 10/26/00 9:59 AM Page 4

Before First Use:

After unpacking the

blender, wash everything except the

blender base in hot, soapy water. Dry

thoroughly. Wipe the blender base with

a damp cloth or sponge. DO NOT

IMMERSE THE BASE IN WATER.

Care should be taken when handling

the cutting blades as they are very sharp.

How to Assemble and Use

IMPORTANT:

Your blender jar and

cutting blades are subject to wear during

normal use. Always inspect jar for nicks,

chips, or cracks. Always inspect cutting

blades for broken, cracked, or loose

blades. If jar or cutting blades are

damaged, do not use. Call our toll-free

customer assistance number to obtain

replacement parts.

1. Make sure blender is unplugged.

Place blender base on clean, dry

surface to keep foreign particles

from being pulled up into motor

during operation.

2. Place blades in retaining ring. Fit

gasket over blades. The gasket must

lie flat. Set jar on top of gasket and

screw on retaining ring.

3. Make sure the retaining ring is

firmly screwed onto the jar. If not,

it may loosen later when motor is

turned on.

4. Set jar into place on blender base,

making sure it is securely seated. If

not, gendy rock the jar until seated.

5. Make sure the blender OFF button

has been pushed. Plug cord into

oudet

6. Put ingredients in jar; place lid

on jar. Place hand on lid when

blending thin liquids.

7. Process food or beverages. See the

“Blending Techniques” section for

speeds and processing tips.

8. ALWAYS turn blender off and wait

undl blades have stopped rotating

before removing jar.

9. To remove jar after blending is

complete, lift the jar straight up.

If it is not easily removed, rock

gendy and lift. Do not twist

10. NEVER replace jar onto unit while

motor is running.

12-Speed Control Panel

First select and push a LO or HI power

button. Then push the desired speed

button. The blender will run until you

push the OFF button. The OFF button

is also the CRUSH/PULSE button.The

blender runs only as long as the button

is pushed. On LO power the blender

pulses and on HI the pulsing action is

powerful enough for crushing ice. See

“Crushing Ice.”

Advertising
This manual is related to the following products: