GE 2-9876 User Manual
Page 21
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ANSWERER OPERATION
The memory full condition is indicated by rapid flashing of
the MESSAGES display. Memory full condition occurs if 14
minutes of announcements and messages have been
recorded, or if 40 messages have been recorded. Erasing
messages will eliminate this condition. “Memory Full" will be
voiced at the start of any mailbox play when condition exists.
Note: When memory is full, unit will only answer after 10th
ring and will not record any new messages. (See page 27.)
if the unit does not seem to be functioning properly;
disconnect telephone tine cord and pull the AC/DC POWEfi
CORD from the POWER 9VDC JACK on the back of the
Answerer. Remove the 9 volt battery, wait at least 5 seconds
and plug back in. All messages/memos and announcements
will be erased. Time and Day have to be re-entered and the
announcements re-recorded.
Note; Disconnecting the AC/DC POWER SUPPLY at the
110V AC wall plug will not reset the answerer.
T.
When
Memory
is Full
u.
Answerer
Reset
21