GE VVVVA8876M User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I
PROBLEM
POSSIBLE CAUSE AND REMEDY
WATER WON’T
DRAIN
• Make sure drain hose is not kinked.
• Top of drain outlet should be less than 8 ft. above floor.
WATER LEAKS
• Make sure hose connections are tight at faucets.
• Make sure end of drain hose is correctly inserted in and secured to drain facility.
WASHER IS NOISY
• Make sure washer is level and firm to the floor with rubber foot pads in place and
front jam nuts tight. See your Installation Instructions.
• A sharp distinctive sound will be heard at the end of each spin period as the motor
stops and the spin brake inside the transmission “locks in!’ This sound is normal.
• Heavily unbalanced loads can cause the washer to vibrate excessively during spin,
and may cause it to move from its original position. In extreme cases, (usually occurs
when washing a single, heavy item or a small load when water level is set higher than
necessary) the spin basket may strike the outer tub, creating a loud but harmless noise.
To correct, open the lid and redistribute the load evenly about the wash basket. Close
the lid and restart.
WASHER PAUSES
IN CYCLE
• Washer normally pauses between washing steps... such as between wash and spin or
between spin and rinse.
I
If you need more help.. .call, toll free:
GE Answer Center®
800.626.2000
consumer information service
25