GE 49-8338 - Manual (Page 44)

d
5. To prevent leakage, make sure the oriJice
spuds are securely screwed into the gas inlet
tubes. Use a small wrench to hold the inlet tube
hex to prevent it from twisting.
6, Put old orifice spuds back in the bag to save
for possible future conversion.
Note: K an orifice spud is accidentally
dropped, the cooktop
.
can be raised by
disengaging
the 2 front clips
with a large flat
blade screwdriver.
\ ^
DO NOT attempt to rmse the cooktop without
removing all 4 burner bases.
K wires were disconnected to remove the
cooktop, feed wires through the burner holes m
the coolrtop. Attach to each burner electrode
terminal carefully, making sure not to bend the
terminal. Then lower cooktop until it snaps
over tile clips.
-
Electrode
I ail screw
7b Carefully insert burner bases straight down
with the tube over the orifice spud. Replace the
screws, making sure the tall screw is
opposite the burner electrode in each
burner base.
IAI CiiwiiTiii iliillCi §11
MODEIS EQUIPPED WITH DUAIBURMERS
(See Step 3 if range is equipped with sealed burners.)
1. Lift cooktop.
2. lift burner assemblies straight up and set
aside to gain access to surface burner spuds.
3. With a 7mm
or 5/16" wrench
(depending on the
size of your
spuds), remove
each of the four
spuds on the
surface burner gas
inlet tubes and
replace them with
the correct gas
spuds mounted in
a liuiuci at tiiKz
right rear of the range, above the regulator.
Natural gas spuds are brass and LP gas spuds
are red or silver. (Mount the spuds that you
removed from the inlet tubes back in the holder.)
securely screwed into gas inlet tubes.
4* Replace the burner assemblies.
5. Keep all spuds with your range so you have
them if vou move or get a different gas hook-up.
S] ABIUSf
OVEN THERMOS!«
(for Models Equipped with Standing Pilots)
1. Remove the oven
control knob.
2. Locate the thermostat
adjustment screw at left of
thermostat shaft. Turn
screw clockwise until the
------- ^11 „4- T r> TVT
smcui puuitci i5> ai i_<x ui ,
depending on the type of
gas you are converting to.
3. Replace oven control knob.
(continued next page)
43