GE ADW! 000 SERIES - Manual (Page 7)

Operation of models with cycle dial
ge.com
' Platfi Warmer
Rinse Only
For rinsing partial loads that will be washed later. Do not use detergent.
2 Make sure HEATED DRY Is not selected. j Slowly turn the Dial to RINSE ONLY.
2 Be sure the door is unlatched. ^ Latch the door to start the cycle.
Plate Warmer or Drying
For warming clean dishes and serving plates. This cycle will take approximately 39 minutes.
Load clean dishware to be warmed.
2 Select HEATED DRY ON.
^ Be sure the door is unlatched.
^ Slowly turn the Dial to PLATE WARMER or
^DRYING.
^ Latch the door to start the cycle.
CO
Q
ft)
U)
a
o'
o
0)
Hot Start or Hot Prestart Option
Preheats wash water.
2 Select the HOT START or HOT PRESTART
.....cycle and any other option on the push
button pad.
Be sure the door is unlatched.
7 ilowly turn the Dial to HOT START or
HOT PRESTART.
¿ 1 ^ Latch the door to start the cycle.
Short Wash or Light Wash or Water Saver
For quickly washing loads of everyday dishes with light to medium soils that have not dried on.
: Be sure the door is unlatched. ^ Latch the door to start the cycle.
.--y.". Slowly turn the Dial to SHORT WASH,
ShBDIBd Dry off) • ■. '■ ■ ' ■ • ■. '■ ■
‘ LIGHT WASH or WATER SAVER.
Start Delay Ion some models)
The START DELAY will allow you to delay the start time of any cycle automatically up to 6 hours.
: 1 ■ Be sure the door is unlatched. 7 Slowly turn the Dial to the desired time.
The CYCLE ON light will come on.
2;' Select the wash cycle and option you want. Latch the door to start the cycle.
O
C
cr
rS"
0)
3“
o
o
3*
tQ
■D
U)
start (Models with a Dial)
Slowly turn the Dial to the START or ON position, or the selected cycle. Don't turn it past the START,
ON or cycle position; you could accidentally miss a prewash.
There is a time delay between start-up and water fill so you will not hear any wash action right
away.
Latch the door to begin the cycle.
O
O
3
u>
c
(X)
CO
■D
O