Kenmore 665.75022 - Manual (Page 20)

Ovcir'i L i g h t
The oven light is a standard 40-watt appliance bulb. It will come
on when the oven door is open. It will not worK during the Self­
Cleaning cycle. When the oven door is closed, press the OVEN
pad to turn on and off.
Before replacing, make sure the oven and cooktop are cool and
the control knobs are off.
To Replace:
To Remove:
1. Open the oven door. Insert door removal pins, included with
your range, into both hinge hangers. Do not remove the pins
while the door is removed from the range.
1 .
2 .
Unplug range or disconnect power.
Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
2 .
3.
4.
1. Removal Pins
2. Hinge Hangers
Carefully close the door until it rests against the door removal
pins.
Grasp the door on the sides with your fingers on the front of
the door and your thumbs on the inside surface.
Pull door straight up, then toward you. Hinge hangers will
slide out of front frame hinge slot. Do not remove door
removal pins until the door is replaced on the range.
O'veil Door
For normal range use. it is not suggested to remove the oven
door. However, if necessary, follow these instructions. The oven
door is heavy.
Before Removing:
1. Use a putty knife or screwdriver and insert it at the bottom
corner of the door stop clip.
7. Door Stop Clip
2. Pry door stop clip free and remove from front frame hinge
slot. Take care not to scratch finish.
3. Repeat procedure for other door stop clip.
20