Generai care & cleaning (cont’d), If n e cessa ry – Kenmore 790.7011 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Generai Care & Cleaning (cont’d)

Cleaning Chart

Surfaces

How to Clean

Glass,

Painted

Plastic Body Parts

&

Control Knobs

Fo r g e n e ra l cle a n in g ,

use a soft cloth, clean with mild dish detergent & water or a 50/50 solution

of vinegar & water. Follow by rinsing the area with clean water; dry & polish with a soft cloth.
Glass cleaners may be used if sprayed on a soft cloth 1st.

DO NOT

spray liquids directly on the

control pad and display areas.

DO NOT

use large amounts of water on the control panel - excess

water on the control area may cause damage to the appliance.

DO

NOT

use other liquid

cleaners, abrasive cleaners, scouring pads, or some paper towels - they will damage the finish.

Painted Control

Panels & Display

areas

B e fo re clea n in g th e co n tro l p a n e l,

turn all controls to OFF & remove the control knobs. To

remove, pull each knob straight off the shaft. Use the

g e n e ra l cle a n in g

instructions provided in the

paragraph above.

Porcelain Enamel

Burner Grates,

Cooktop Surface,

Broiler Pan & Insert,

Broiler Drawer, Door

Liner

&

Oven Bottom

Clean burner grates, broiler pan & insert in the dishwasher and dry upon removal. If soils are not
removed, follow the cooktop cleaning instructions below.

Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 1:1 solution of
clean water & ammonia.

If n e cessa ry,

cover difficult spots with an ammonia-soaked paper towel

for 30 to 40 minutes. Rinse with clean water and a damp cloth, then scrub with a soap-filled
scouring pad. Rinse & wipe dry with a clean cloth. Remove all cleaners or the porcelain may
become damaged during future heating.

DO NOT

use spray oven cleaners on the range top.

Oven Racks

Remove racks. See "Removing & Replacing Oven Racks" under Before

Setting Oven Controls.

Use a mild, abrasive cleaner, following the cleaner’s recommendations. Rinse with clean water &
let dry. After cleaning the racks, rub the sides of the racks with wax paper or a cloth containing a

small amount of salad oil (this will make the racks glide easier into the oven rack positions).

Oven Door

Use soap & water to thoroughly clean the top, sides & front of the oven door. Rinse well. You
may use a glass cleaner on the outside glass of the oven door.

DO NOT

immerse the door in

water.

DO NOT spray

or

allow water or the glass

cleaner

to enter

the

door vents.

DO NOT

use oven cleaners, cleaning powders or any harsh abrasive cleaning materials on the outside of
the oven door.

DO NOT

clean the oven door gasket. The oven door gasket is made of a woven

material, on Self-Cleaning models, which is essential for a good seal. Care should be taken not
to rub, damage or remove this gasket.

Stainless

Steel

Clean

stainless

steel with hot soapy water & a dishcloth. Rinse with clean water and a cloth.

DO NOT use cleaners with high conecentrations of chlorides or chlorines. DO NOT use harsh

scrubbing cleaners. Only use kitchen cleaners that are especially made for cleaning stainless
steel. Always be sure to rinse the cleaners form the surface as bluish stains may occur during
heating that cannot be removed.

Countoured well

areas, bruner caps

&

burner heads

See

Cleaning the Countoured Well

Areas,

Burner Caps

&

Burner Heads

section for

complete details.

Cleaning the

Cooktop

The cooktop is designed to make cleaning easier. Because the four burners are sealed, cleanups are easy when spillovers
are cleaned up Immediately. To clean, wipe with a clean, damp cloth and wipe dry.

Cleaning the Contoured Well Areas, Burner Caps & Burner Heads

The contoured well areas, burner caps and burner heads should be routinely cleaned. Keeping the burner ports clean will

prevent improper ignition and an uneven flame. Refer to the following section for instructions.

THE COOKTOP IS NOT REMOVABLE.

Do not attempt to remove or lift

the

cooktop.

^CAUTION

Use caution when replacing the burner cap

so the electrode is not damaged. This may cause a
delayed ignition or prevent the burnerfrom igniting.

^CAUTION

|Anyadditions,changesorconversions

required

in order for this appliance to perform satisfactorily must be
made by an authorized Sears Service Center.

11

Advertising
This manual is related to the following products: