Kenmore 625.384600 - Manual (Page 4)

PARTS OF THE SYSTEM MATERIALS AND TOOLS NEEDED
y* filter system assembly including mounting brack­
et and screws
y water supply fitting
y filtered water faucet for sink or countertop mount­
ing
y tubing to make all needed connections
• plumbers putty
• slotted and Phillips screwdrivers
• pliers and adjustable jaw wrench
• tubing cutter
• sandpaper or emery cloth
• electric drill and 3 / 4" drill bit if mounting hole is
needed for the faucet, see page 6
CAUTION; To avoid damaging the sink, consult a
qualified plumber or installer for drilling procedures
in porcelain or stainless steel.
FIG. 1
TYPICAL UNDERSINK INSTALLATION
T
DiSn _
tittered water
faucet
SINK
HOT COLD
shutoff valve
Note: To change the fil­
ter cartridge, you must
turn off the water and re­
lease pressure by open­
ing the faucet. A nearby
shutoff valve is conve­
nient. Most sinks al­
ready
have shutoff
valves on the supply
pipes.
WATER
OUT
supply fitting
\
Filter II
Filter I
Note: Be sure to allow a minimum space of 1-1/2” under
the system for removing the sumps, to change the
cartridges.