Kenmore 385. 17622 User Manual
Page 17
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Stitch Selector
I
ir__ _ ^7i
.^lector Release
1) Raise the needle to its highest position.
2)
Select the desired pattern at the setting mark(T)by turning the pattern selector
dial. Dial will not turn past "SELECT" without moving selector release to the
right.
When you select patterns A to I
a)
First, slide the selector release to the right so that the "SELECT A to I" mark
on the selector release meets the setting mark(2)on the machine.
b)
Then, select the desired pattern at the setting mark 1 by turning the pattern
selector dial.
c)
Slide back the selector release to the left so that the "SEW" mark on the
selector release meets the setting mark(2)on the machine.
Note: Do not turn the pattern selector dial while the needle is in the lower
position. It may cause the needle to'break.
SECTION 2. PREPARE THE MACHINE FOR SEWING
Stitch patterns are color-coded to recommend setting zones at the stitch
length control.
'
ZONES
• Red...................... Straight, Zigzag and Utility Stitches
• Green................... Geometric Decorative Stitches
• Blue...................... Built-in Buttonhole Making
• Brown................... Stretch Stitches
15