Kenmore PLASMAWAVE 85450 - Manual (Page 9)

FILTER REPLACEIVIENT
Filter Replacement
0
There are two separate filters:
True HEPA Filter and Carbon Pre-Filter.
•> The CHECK FILTER indicator will signal
when to replace the True HEPA Filter. The
replacement period will vary depending on
the houre of usage, air quality, and location
of the unit. However, In most cases of
normal use the filter will need to be
replaced annually
» Change the True HEPA Filter when
the CHECK FILTER indicator is on.
» For best performance, change the
Carbon Pre-Filter every three months.
This filter should be disposed of when
changed.
Carbon Pre-Filter Replacement
1. Turn off the air cleaner and unplug the
electrical cord.
2. Remove the front panel by pulling gently
from the lower portion of the panel. Do
not force, toe panel should remove easily.
3. Remove toe Carbon Pre-Filler and
plastic frame by gently pulling out from
the bottom and down from the top.
4. Remove the Carbon Pre-Filter from the
plastic frame and dispose of it
5. Remove a replacement Carbon Pre­
Filter from the resealable plastic bag
and reseal to maintain the freshness of
the remaining filter,
6. Install the Carbon Pre-Filter onto the
plastic frame by pushing against six
“hook and loop” squares on the back of
the frame. (Diag, 6A)
7. Install the plastic frame by Inserting tabs
up into the air cleaner and gently pushing
in at the bottom tab until the frame fits
into place snuggly
8. Replace the front panel by hooking the
panel on the top of the unit. Swing the
panel in by pushing gently on each side
of the unit and then lock It into place.
9. Plug in air cleaner and press POWER
button until short “beep" sounds
CAUTION: Do not wash and reuse the
True HEPA Filter or the Carbon Pre-Filter
as they will not work effectively.
10