Kenmore 790.75604 - Manual (Page 16)

Setting Warmer Drawer Controls
Removing and Replacing Warmer Drawer
Warmer (Warm & Ready™) Drawer Indicator Light
The indicator light is iocated above the warmer drawer thermostat control. It turns on when the control is set, and stays on until
the control is turned off. The warmer drawer is inoperable during the self-dean cycle. The indicator light wiil not come on during
the self-clean cycle.
To Remove and Replace Warmer (Warm & Ready™) Drawer
To Remove Warmer Drawer:
^CAUTION Turn power off before removing the warmer drawer.
2. Open the drawer to the fully opened position.
3. Locate glide lever on each side of drawer, pull up on the left glide lever and
push down on the right glide lever {see figure 1).
5. Pul! the drawer away from the range.
To Replace Warmer (Warm & Ready™) Drawer:
1. Pul! the bearing glides to the front of the chassis glide (see figure 2).
2. Align the glide on each side of the drawer with the glide slots on the range.
3. Push the drawer into the range until levers “click” {approximately 2”). Pul! the
drawer open again to seat bearing glides into position. If you do not hear the
levers “click” or the bearing glides do notfeel seated remove the drawer
and repeat steps 1 thru 3. This will minimize possible damage to the bearing
glides.
NOTE: The Warmer Drawer will NOT operate while in the Self-Clean and “Oven
Lockout” modes'.............................................................................................................
ii WARNING Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance from electric
power before cleaning and servicing the warmer drawer.
16