Pioneer CT-S250 - Manual (Page 2)

IMPORTANT 1
A
The lightning flash with arrowhead, within an equilateral
triangle, is intended to alert the user to the presence of
uninsulated 'dangerous voltage' within the product's
enclosure that may be of sufficient magnitude to
constitute a risk of electnc shock to persons.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO PREVENTTHE RISK OF ELECTRIC SHOCK, DO NOT
REMOVE COVER (OR BACK). NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.
A
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating artd maintenance (servicing) instructions in the
literature accompanying the appliance.
IMPORTANT 2
FOR USE IN THE UNITED
KINGDOM
The w^ee in this manís lead are eotoured in
accordance with ^ f(^owing code:
Blue : Neutral
Brown ; Live
If the plug provided is unsuitable for your socket
outiets, the plug must be cut off and a suitable plug
fitted.
The cut-off plug should be disposed of and must not be
Inserted into any 13 amp socket as this can result in electric
shock. The plug or adapter or the distribution panel should
be provided with a 5 amp fuse. As the colours of the wires
in the mains lead of this appliance may not correspond with
the coloured markings identifying the terminals in your plug,
proceed as follows:
The wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured black.
The wire which Is coloured brown must be connected
to the terminal \Aiiich is marked with the letter L or coloured
red.
Do not connect either wire to the earth terminal of a
three-pin plug.
NOTE
After replacing or changing a fuse, the fuse cover in the
plug must be replaced with a fuse cover which corre­
sponds to the colour of the insert in the base of the plug
or the word that is embossed on the base of tiie plug, and
the appliance must not be used without a fuse cover. If
lost, replacementfuse covers can be obtained from your
dealer.
Only 5 A fuses approved by B.S.I. or A.S.T.A to B.S.
1362 should be used.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures;
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
Information to User
Alteration or modifications carried out without appropriate authorization may invalidate the user's right to operate the equipment.
2
<RRB1172>
En