Pioneer PDP 507CMX - Manual (Page 3)

P o w e r f u l F u n c t i o n a l i t y
Dual Screen Function
standard Dual Screen Mode
Remote and RS-232 control operation permits the use of Picture-in-Picture
(P-in-P) and Side-by-Side modes. With P-in-P, the position of the sub-image
can be shifted among four locations, or Side-by-Side images can be switched
between the left and right positions. Audio can also be independently switched.
P-in-P Fade In/Out
This function allows an optional fade in/out transition of the sub-picture.
Upgraded Side-by-Side Mode
Switch easily between Side-by-Side and P-out-P modes. It is also possible to select
three horizontal aspect ratios for dual-image, full-screen display.
P-in-P Display Variations
The P-in-P mode permits a number of display variations. There are multiple
sizes of P-in-P sub-images which can be set in addition to the transparency of
the sub-image from 0 to 80%.
Sub-Image Detection
During P-in-P display, if the sub-image input signal is lost, the display will
automatically switch to a full-screen image. P-in-P is automatically restored
when the sub-image signal returns.
Ordinary PDP-507CMX
Banner Mode
Easily display titles / captions prepared in PowerPoint® or other presentation
software. There are ten positions for the titles / captions: eight horizontal
settings and two portrait modes. The transparency of the on-screen titles can
also be varied. * PowerPoint is a registered trademark of Microsoft Corporation.
1. TOP 1-3
2. MID HIGH
3. MID LOW
4. BOTTOM 1-3
Video Wall
Use as Many as 25 PDFs
Pioneer makes it easy to configure
multi-monitor video walls without
any additional equipment. Possible
configurations are 2x2, 3x3, 4x4
and 5x5.
Two Display Modes
Adjusted mode
for a more natural
looking image
across screen
mullions.
PDP-51 )7CVrX
yikisr A
VW A iWim
l3B5r )i 768
Normal mode
for showing all of
the screen
information.
Portrait mode
Dual Image Freeze
Dual Image Freeze temporarily freezes a displayed image. The still image can be
the sub-image in P-in-P mode or the left-side image in Side-by-Side mode.
Power On Delay
This function automatically delays the powering up of each display to reduce
the load on the power source.
ABL Link
The ABL (Auto Brightness Limiter) Link
function sets the brightness of each
display at a uniform level (operates only
with 2x2 and 3x3 configurations).
Frozen image Current image Frozen image Current image
Auto ID Setting
Automatically sets an ID for each display connected via a combination control
cable to permit simpler error-free setting (operates only with 2x2 and 3x3
configurations).