Wall mounting instructions, Installation information (cont.), Quick set-up guide – Cobra Electronics CP-705 User Manual

Page 2

Advertising
background image

Wall Mounting Instructions

The following steps enable installation on a new or existing telephone wall-
mounting plate or directly onto a wall.
(Your Cobra INTENNA is designed to
be used with any AT&T, GTE, local phone company or other wall-mounting
plates that can be purchased from most local electronics stores.)
•

Plug modular phone connector into telephone wall jack.

•

Align mounting studs on the plate to the holes on the bottom of the INTEN-
NA base; push base onto studs and slide down on the wall plate.

•

Wrap doubled cord around bottom of base. Cord can be hidden between
bottom of base and wall-mounting plate.

•

Attach the power adapter to the POWER connection (on the base of the
phone) and plug into a household AC power outlet.

•

To install directly on any wall, you’ll need to provide two screws and wall
anchors; follow these steps:

— Drill two holes 3 1/4” apart and insert the wall anchors.
— Drive the screws into the anchors until the head of each screw is

protruding about 1/8” from the wall.

— Align the holes in the cordless base over the screw heads; push base

in and slide down on screws (see diagram #3).

— Plug modular phone connector into telephone wall jack; attach the

power adapter to the POWER connection (on the base of the phone)
and plug into to a household AC power outlet.

Diagram #3:

Installation

directly on a wall

(3)

Diagram #2: In-

stallation on a

telephone wall-
mounting plate

Modular Phone Jack

Screw Heads

Mounting Studs

Modular Phone Jack

Installation Information (Cont.)

• Never install telephone wiring during a lightning storm.

• Never install telephone jacks in wet locations unless the jack is specifically

designed for wet locations.

• Never touch uninsulated telephone wires or terminals unless the telephone

line has been disconnected at the network interface.

• Use caution when installing or modifying telephone lines.

Quick Set-Up Guide

The following basic steps enable quick and easy installation of your new Cobra
INTENNA cordless phone for use on a desk or countertop. You are encouraged
to review this complete instruction manual to become familiar with all of the
operating instructions and features of your new phone.

NOTE: Before using, connect your new phone to AC power — see instruction
below — to charge it overnight (at least 12 hours) for optimum conditioning
of the rechargeable batteries inside the cordless handset.

• Insert the round connector of the power adapter into the POWER jack (at

the rear of the cordless phone’s base; see diagram #1 below) and plug the
power adapter into a standard 110V household electrical outlet. Then
place the handset into the base so the CHARGE indicator lights.

STOP: Charge your phone overnight before proceeding with installation.

• After charging, remove the twist-tie from the phone cord and plug the

modular telephone connector into the phone jack on your wall.

• Make sure that the RINGER switch is ON (located at the rear of the base).

• Set the PULSE/TONE switch (also at the rear of the base) for proper opera-

tion (see page 7 for details).

OFF ON P T

RINGER PULSE/ POWER

TONE 9VDC

Diagram #1:

Connecting

your phone's

AC power

adapter cord

(2)

Ringer

On/Off Switch

Pulse/Tone Switch

AC Power Jack

Advertising