Kenmore 580.76100 - Manual (Page 7)

NSTALLATION
m Select the position that will place the sill supports
near the outermost point on sill (FIG. 10).
Attach the sill supports to the cabinet track hole
ctosest to the setected posioti using screw (ITEM E).
1
rrews
^ ................ . ............................... ... Ì ^
£ # /
t
f
1
B®0C« 1
OuTOOfi
FIG. 10
H
Place the si supports with the cabinet on the
window sill's sslected: frasitlon.
The cabinet should be installed with a vary
slight tilt (aboiJ 1/4") downward toward the outside
(FIG. 11).
Adjust toe bolts and the nuts of si supports to level
toe catoinet.
screws (ITEM F) through the Lower Guide into the
window inner si (FIG. 12).
Attach each side curtain to the window sash using
screws (ITEM G). (FIG. 13)
if
Attach the L BRACKET (ITEM J) with screw
(ITEM G), (FIG. 14)
Be sure to insert the drain pipe into base pan before
installafion.
The air condloner must be installed with a stlght tilt
(1/4') downward to the outside for proper drainage of
excess condensed' water toraugh the drain pipe.
(RG. 15)
BASE PAN REAR
DRAIN
BASE PA« BOTTOM
FIG. 15
IP Slide the chassis into the cabinet. (FIG. 18)
CAUTION; For ssourtty purposes, reinstall side
screws you removed In step 1.
^ FÌG. IS
22 Cot tos: foam strip (ITEM H) to the proper length
afw insert between the upper window sash and the
lower window sash. {FIG. 17)
K The vent control handle must be straightened
ire the decorative front is attached.