To turn ionizer on/ off (see fig. 2 f), To set timer button (see fig. 2 e) – Kenmore 437.85264 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION cont.
Each time you start your Air Cleaner, we recommend that you
run it at Turbo speed for a few minutes for fast initial cleaning.
The Ionizer, when turned ON, adds negative ions to the exiting
stream of clean air. This function provides additional air freshening
and revitalization. Then set it to HI, MED, or LO as desired.
TO TURN IONIZER ON/ OFF (See Fig. 2 F)
Press the Ionizer Button to turn Ionizer ON.
The ION icon on control board will light up.
To turn Ionizer OFF, push button again.
TO SET TIMER BUTTON (See Fig. 2 E)
Your air cleaner has a timer function that allows you to
select the number of hours you want it to run and then shut off.
Press timer button once and the air cleaner will run for 1 hour.
Each time you press the button extends the time 1 hour.
Example: 2 pushes = 2 hours, 4 pushes = 4 hours, etc. Up
to
8 pushes = 8 hours.
For Continuous Running: Push button 9 times.
NOTE: When the unit is first turned ON, it is normal to hear snapping
sounds that are a result of arcing in the cell. Cell arcing may be caused
by high humidity (70% or more) in the room, by hair or large particles of
dirt caught in the cell, or by dampness remaining in the cell after it is
washed. If snapping sounds do not eventually stop, TURN UNIT OFF and
follow instructions for CLEANING THE CELL.