Removing the old cassette ribbon, Inserting the new cassette ribbon, Removing the old ribbon – Brother EM-430 User Manual
Page 11: Inserting the new ribbon, Spacebar, Bksp
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting up the Typewriter
Removing the old cassette ribbon
First, use the
[SPACEBAR]
or
[BKSP]
key to move the carrier to the center of the platen.
To remove the cassette ribbon, hold the cassette with both hands and raise the front end
(that near to the platen). Then, when the ribbon is clear, simply lift the cassette up and out.
Inserting the new cassette ribbon
Remove the stopper from the new cassette ribbon and turn the ribbon feed knob counter
clockwise to tighten the ribbon.
Now locate the lugs on the back edge ofthe cassette into the locating holes in the cassette
ribbon table, and slide the ribbon between the ribbon guides.
With the ribbon set between the ribbon guides, press the cassette down until it locks into
place. Turn the ribbon feed knob again slightly counter clockwise to tighten the ribbon.