Pioneer CT-W603RS - Manual (Page 12)

PLAYBACK
SINGLE PLAYBACK
(Either DECK I or DECK II) RELAY PLAYBACK
1. Load a prerecorded tape in DECK I or II.
2. Set the DOLBY NR ON/OFF switch and set the DOLBY
NR switch.
• Set the DOLBY ON/OFF switch to ON first, then select B, C
or S-type NR with the DOLBY NR switch.
• Always set the switch to the same position that was used
for recording.
3. Set the REV MODE switch to or => (see page 8).
4. Set the stereo amplifier for tape playback.
5. Press the playback (^ or button of either DECK I or
II.
To improve high frequency sound during playback in
tapes with poor recordings
Press the FLEX button and playback the tape.
To stop playback temporarily (Except for DECK I of
CT-W603RS)
Press the pause (II) button.
• To resume playback, either press the pause (II) button again,
or press the playback (►or ◄) button.
To stop playback
Press the stop (■) button.
This function allows you to skip unrecorded portions of the tape
during playback.
Set the REV MODE switch to
• When this mode is selected, if the tape deck encounters an un­
recorded portion of tape more than 15 seconds in length, it will
fast forward the tape until it encounters another recorded por­
tion, and resume playback from that point.
When relay playback mode is selected, continuous playback can
be performed. When the tape in the first deck reaches its end and
stops, the other deck will automatically begin playback.
1. Load prerecorded tapes in DECK I and DECK II.
2. Set the DOLBY NR ON/OFF switch and set the DOLBY
NR switch.
• Set the DOLBY NR ON/OFF switch to ON first, then select B,
C or S type NR with the DOLBY NR switch.
• Always set the switch to the same position that was used
for recording.
3. Set the REV MODE switch to (see page 13).
4. Set the stereo amplifier for tape playback.
5. Press the playback (► or button of the deck that
will start to play first.
• When the tape in one deck ends, the other deck automati­
cally begins playback.
• To cancel relay playback, press the STOP (■) button.
To improve high frequency sound during playback in
tapes with poor recordings
Press the FLEX button and playback the tape.
NOTES:
• Relay playback can begin from either DECK / or DECK II.
•
The tape in the idle deck can be replaced during relay playback
mode, allowing many tapes to be played back continuously.
This is a convenient feature for parties, background music, etc.
• When this mode is selected, if the tape deck encounters an un­
recorded portion of tape more than 15 seconds in length, it will
fast forward the tape until it encounters another recorded por­
tion, and resume playback from that point
To stop playback temporarily (Except for DECK I of
CT-W603RS)
Press the pause (II) button.
• To resume playback, either press the pause (II) button again,
or press the playback (►or -4) button.
To stop playback
Press the stop (■) button of the operating deck.
NOTE:
• When the REM MODE switch is set to >
will be engaged automatically.
< position, relay mode
12
<RRB1143>
En