CTC Store Xerox Corp. Ethernet Switch FSW2104 - Manual

Specifications
Fiber Connector Type SC, FC or ST type
Fiber Wavelength 1310nm (typical), 1550nm (optional)
Transmission distance 0 ~ 120km (optional),
depends on the transceiver model
Ethernet port 10/100Base-Tx (Auto-negotiation)
supports VLAN Tag (max. length 1536 bytes)
64K MAC address table
1M Byte packet buffer memory
Voltage input scope 100~245VAC, 50/60Hz
-36~ -72VDC
Built-in power supply < 5 Volts
Installation Instructions for Installation Instructions for
4 Port 10/100Base 4 Port 10/100Base - - TX Ethernet Switch TX Ethernet Switch
with 1 Port 100Base with 1 Port 100Base - - FX Uplink FX Uplink
Optical Fiber Switch Optical Fiber Switch
Description
The FSW2104 is an unmanaged 4 port 10/100 switch with one 100Base-FX Fiber uplink.
They are designed for small workgroup applications that require a long distance
connection to the backbone, such as between buildings, offices, or within a campus
location. These switches provide port speeds up to 200 Mbps and full-duplex capability on
each auto-sensing port, for enhanced performance. A wide range of transceiver selection
provides fiber connection with SC, FC or ST type connectors, in multimode or single
mode and at distances from 2 to 120KM.
Environment
Temperature : 0℃ - 50℃
Humidity 10-90% non condensing
Dimension
213mm x 106mm x 33mm
(H x W x D)
Power
+9V / 600mA maximum
V.: 1.1
Fiber Fiber
Connection Connection
Ethernet Connections Ethernet Connections
LED LED
Indications Indications
Power Switch Power Switch AC Jack AC Jack
ON ：Connection is made
OFF ：No connection is made
Blinking
：Transmitting or Receiving
TL1 , TL2 , TL3 & TL4
ON ：Connection is made
OFF: No connection is made
Blinking
：Transmitting or Receiving
FL
ON
：Power ON
OFF ：Power OFF PWR
Status Description LED Indicator
TX
：transmit data
RX ：receive data Fiber FX
Status Description Indicator Interface
Application
Internet