Chief Manufacturing PNRIWU User Manual
Page 4
PNRIW / PNRIWU
Installation Instructions
4
Installation
The following procedure assumes that a Chief Model PAC501
In-Wall accessory has previously been installed following the
installation instructions provided with the PAC501. If a PAC501
is not installed or there are any other questions regarding the
installation of this accessory, immediately contact a Chief
Customer Service representative by calling 800-582-6480 or by
visiting www.chiefmfg.com.
WARNING:
IMPROPER INSTALLATION CAN LEAD TO
MOUNT FALLING CAUSING SEVERE PERSONAL INJURY
OR DAMAGE TO EQUIPMENT! DO NOT deviate from
installation instructions provided. DO NOT substitute
hardware.
1.
Align mounting holes in swing arm UPPER and LOWER
mounting brackets with four mounting holes in PAC501.
(See Figure 2)
Figure 2
2.
Secure swing arm to PAC501 using four button head cap
screws (C), four lock washers (D) and four flat washers (E).
(See Figure 3)
Figure 3
Trim Installation
To install optional trim;
1.
Remove paper covering adhesive and affix three tape
squares (F) to inside lower flange of each trim piece (B).
(See Figure 4)
2.
Orient trim pieces (B) as shown in figure below.
(See Figure 4)
3.
Remove paper covering adhesive back from tape squares
(F) on trim and press trim (B) against inner wall of box.
(See Figure 4)
Figure 4
1
1
1
Upper Mounting Bracket
Lower Mounting Bracket
(C) x4
(E) x4
(D) x4
2
(F) x 12
1
(B) x 4
3
2