Cobra Electronics MICROTALK CXR725C - Manual (Page 5)

Customer Assistance Warranty Introduction
5
Operation
4
Using Your Radio
Channels
•
With the radio on, select any of the
22 channels by pressing the Channel Up
or Channel Down button.
Both radios must be tuned to the
same channel to communicate.
Channels 1 through 7 are shared by FRS and
GMRS. Channels 8 through 14 are FRS only.
Channels 15 through 22 are GMRS only.
See page 26 for FRS/GMRS frequency
allocations and compatibility charts.
Listening for a Response
•
Release the Talk button to receive incoming
transmissions. Your microTALK radio is always
in Standby mode while the Talk or
Call buttons are not pressed.
Call Button
•
To alert another person that you are calling:
– Press and release the Call button.
The other person will hear a two second
call tone. This tone is used only to establish
voice communications.
See page 24 on how to select from
10 available call tone settings.
Operation
Selectable High•Low Power Output
•
When in close proximity to another party or
during favorable conditions, you can switch
from High to Low Power to extend battery life.
This feature applies to GMRS Channels
1 through 7 and 15 through 22 only.
Channels 8 through 14 operate
exclusively on low power.
To toggle between high and low power:
– Press and release the Hi•Lo button.
When using Channels 1 through 7 and
15 through 22 on high power, the Hi icon
will be visible on the display.
When using those channels on low power
and on Channels 8 through 14, the Low icon
will be visible on the display.
To Illuminate Display
•
Press and release the Light/Max Range
button to illuminate the display for
10 seconds.
ChannelButton
ChannelNumber
Listening
CallButton
Hi-LowButton
HiPowerIcon
LowPowerIcon
Light/MaxRange
Nothing Comes Close to a Cobra ®
CXR725C_MANL_ENG.indd4-5 12/15/092:10PM