COBY electronic TF-DVD450 - Manual (Page 12)

12
Remote Control
Refer to the diagram. Remove the battery com-
partment cover located on the rear of the remote
control. Insert batteries, making sure to match
their polarities (+/-) to the markings on the inside
of the compartment. Replace the cover.
To use the remote, point it at the remote sen-
sor of the player. Operate the remote within 15
feet of the sensor and at an angle of +/- 60 de-
grees.
Batteries in the remote will last for approximate-
ly 1 year. Replace the batteries if the remote
control does not work. Do not mix old with new
batteries, or different types of batteries.
Remove the batteries from the remote if it will
not be used for a long period of time.
WARNING
The battery used in this device may present a fire or chemical burn if mistreated. Do not
recharge, disassemble, incinerate, or heat the battery (~212○F).
Keep batteries away from children.
Power Supply
Using the AC Adapter
This AC adapter should be used with 100-240V
50/60Hz AC wall outlets.
DC Out: 9V
DC Current: 2.0A max.
Caution:
Do not connect the power plug to a power outlet other than that which is indicated here and
on the label as this may result in the risk of fire or electric shock.
Do not handle the power plug with wet hands. Doing so may cause electric shock.
Only use AC adapters of the type specified here. Failure to do so may case a fire or damage
the player.
Using the Battery Pack (DC)
The rechargeable battery pack can be used for approximately 300 charge-cycles without any
noticeable change in performance.
Important: The battery should be charged fully (minimum 4 hours) before its initial use to
ensure optimum lifetime performance.
•
•
•
•
•
•
•
•
•
•
•
GETTING STARTED
2 x “AAA” 1.5V batteries
To Power Jack
(DC 9V)
To wall outlet
(100-240V 50/60Hz)