Chicago Electric 95283 - Manual (Page 16)

the Drive Gear (44) and into the Guard Bar groove. The cutters on the top of
the Guard Bar should face toward the Guard Bar tip, in the direction of the
chain rotation. Replace the Chain Saw Cover and secure with the Nut. Tighten
the Nut finger tight only to allow for tension adjustment.
Then, follow directions on page 10 of this manual to properly adjust the Chain
tension. (See Figure B, and Figure C.)
NUT
(75)
CHAIN SAW
COVER
(77)
GUARD BAR
(73)
SAW
CHAIN
(74)
CHAIN SAW
COVER
(77)
NUT
(75)
CHAIN
TENSION ASSY.
(38)
DRIVE GEAR
(44)
GUARD BAR
STUD
GUARD BAR
(73)
GUARD BAR
STUD
SLOT
CHAIN TENSIONING
PIN HOLES
NUT
(75)
DRIVE
GEAR
(44)
CHAIN
(74)
CHAIN ROTATION
FIGURE C
1 2
3 4
SKU 95283 For technical questions, please call 1-800-444-3353 PAGE 16
9. CAUTION! All maintenance, service, or repairs not mentioned in this
manual must only be performed by a qualified service technician.
8. When storing the Polesaw/Pruner: Before storing, make sure to install the
Guard Bar Cover (78) onto the Guard Bar (73). Drain all fuel out of the tool’s
Fuel Tank (78A). If this is not followed, old fuel in the Fuel Tank may clog the
Carburetor and prevent the tool from starting until cleaned out. Then store the
tool in a clean, dry, safe location out of reach of children and other unauthorized
people.