Cobra Electronics Pro 9380 - Manual (Page 6)

Settings
Your Detector
Nothing comes close to a Cobra ® 7
UltraBright Data Display Brightness
You can choose from three (3) settings for Brightness of the display.
You can cycle through the settings by repeatedly pushing the Dim button.
The factory setting is Bright.
Settings
Your Detector
6 English
Settings
•
When changing the Settings on your detector, please keep in mind:
■ Buttons can have multiple functions.
■ All settings will be stored in memory when the power is
turned
Off and recalled when the power is turned back On.
Highway/City Mode
Setting your detector to City mode delays all X band audio alerts until
the signal strength reaches Level 3. (A single beep will sound when the
signal is first detected.) This will reduce false alerts while you are driving
in, or near, urban areas where there are many sources for conflicting
X band signals such as microwave towers and automatic door openers.
To change settings, follow the procedure listed below, which indicates
what you will see and hear as you complete each step. The factory setting
is
Highway mode.
Dim Button
Press and
release
Bright
Dark
Dim
Press and
release
Dim
button
City Button
Press and release
City Mode
X K Ka V S c
Highway Mode
X K Ka V S
h
To Change From Highway Mode To City Mode
Press and release
the City button. Tone Visual Display
One (1) beep c appears in the display
To Change From City Mode back To Highway Mode
Press and release
the City button again. Tone Visual Display
Two (2) beeps h
appears in the display
To Change The Brightness To Dim
Press and release
the Dim button
once. Tone Visual Display
One (1) beep Display dims
To Change The Brightness To Dark
Press and release
the Dim button
again. Tone Visual Display
One (1) beep Display remains dim
(no visual alerts will be seen)
To Change The Brightness To Bright
Press and release
the Dim button a
third time. Tone Visual Display
Two (2) beeps Display returns
to full brightness