Kenwood MS-A5 - Manual (Page 15)

D Select the broadcast band.
TAPE TUNER ra
ofp
Press the A.PRESET (automatic
preset) key.
The band will toggle between AM and FM each time the
TUNER key is pressed.
The unit will search the selected band and automatically
store up to 15 stations into memory, after which it will stop
automatically.
In some cases the unit will also mistake frequencies with
powerful static for broadcast stations and store these as
well. If this happens, use the preset procedure shown be­
low to change them to actual broadcast stations.
Call up the number for the station
you wish to change.
(main unit oniyl
Press the A.PRESET (automatic
preset) key.
□ w
Press the P.CALL UP key until the pre- Display
set station that you wish to change is “TTT
tuned in.
• Starting with the number you have selected in D. the unit
will search the selected band and assign stations up to
number 15.
preset on the AM band
Example ^^
Select the desired broadcast band.
h | 2 | 3 | 4 | 5 | 1 5
TAPE TUNER CO
0 ( ^ 0
Select number 5,
Change the broadcast band.
Press A.PRESET key.
FM
If the broadcast band is changed, the preset number will
disappear, but it is still retained in the unit’s memory
1 2 3 4 5 6 -------------1 5
ne^et (using remote control unit only)
Select the broadcast band.
C%\
Press the P.CALL key to select the
desired preset number.
Tune in the station to be preset.
W^TUNING^W
C%\
Press the P.MODE key (on the re­
mote control unit).
Blinks
Display
Press the key until the desired number is displayed.
I Press the P.MODE key to set the cur­
rent station to that preset number.
Stops blinking
Display I
P.MODE
I Repeat the process.
Repeat steps 0 through Q until all 15 preset stations are
set as desired.