Bose 901 Series III User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
e. Connect t h e t e r m i n a l o n t h e left speaker to the termi
nal marked "pos.” "positive." or "plus” on the left channel
output of the amplifier or receiver.
NOTE; Use only the terminals marked " k" and The
terminal marked Is intended for future electronic de
velopments and should
not
be used with conventional
amplifying eouipment.
f Place the speaker marked "Part 2" on the right side of the
room and repeat the connection procedure for the right
amplifier channel.
g If you are using an amplifier rated at over 100 waits rms
per channel, fuse your speakers as outlined in SECTION 3
3. Fusing
Any loudspeaker is subject todamage if the amplifier powering
it should fail. The use of a fast-acting fuse in series with each
speakerwill minimize the possibility of ser ious damage toyour
speaker.
For amplifiers rated at under 100 watts rms per channel, no
fusing is required. Amplifiers rated over 100 watts per channel
should be fused with a fast-blow. 3-ampfuse.
Purchase fuseholders and the appropriate fast-acting fuses
Connect the fuseholders in series with the positive wire going
to each speaker, placing the fuse in an easily accessible
location.
BOSE Corporation recommends the use of the Buss AGC
SeriesortheLittlefuseAGSeriesasspeakerfuses