Kenwood KAC-1021 - Manual (Page 8)

To exhibit the fuif perfor­
mance of this unit, use
speaker cords containing
wires of AWG16 or more.
To ground the unit, remove the
coating on the metailic part of the
chassis to which the battery's
negative terminal is con­
nected, and attach the grounding
cable securely using a bolt.
c( Left speaker
round lead
Power supply cord
c:>
• if you hear noise when starting the en­
gine, connect two line noise filters (op­
tional) to the power supply cords of
this unit as shown below.
Power supply cord
[j-j {yeîîow}
V
jjiJ (option) 8e sure to use a fusibie link, and
connect it directly to the battery's
positive ® terminal.
Interior Engine
© Power supply
cord
(Yellow) @
The wiring length should be as
short as possible. When an exten­
sion is required, use cables with
wires of AWG8 or more.
Soideriess
terminal
cjra
Shrink
tubing
When connecting the cord, be sure
to use soideriess terminals and cap
them with shrink tubings.
Do not allow the cord to direct­
ly contact the edge of the iron
plate by using grommets (sup­
plied).
© ©
Battery TÏÏÏÏT
(En) S