Kenwood 6188EP - Manual (Page 4)

OPERATION AND USE
1) SEHING THE CLOCK
For the first time, set the clock to the correct time, proceeding as follows;
* Press the button
"hour"
until the display shows the hours for the correct time,
then release the button.
• Press the button
"min"
until the display shows the minutes for the correct time,
then release the button.
When setting the correct time, the numbers will flash on the display.
The flashing of the numbers will continue for a few seconds after the adjustment has
finished then stop on the correct time and the clock start working.
To change the time, press pushbuttons
"hour"
or
"min"
for at least 5 seconds, then
proceed as above to modify both hours and minutes.
correct time
AM MAN
Of
1 n n
J : u u
0
'Set temperature
2) MANUAL FUNCTIONING
To operate the appliance in "manual" mode, press the "ON MODE" button.
To set the required power level, proceed as follows: press the "ON MODE" button, and then
press again one or more times within 5 seconds to select the power level, as per the fol­
lowing sequence:
Maximum power
Medium power
Minimum power
Off
AM MAN
n o n n
u u : u u
AM MAN
O i
3 n n
j : u u
At any time during "Manual" operation, pressing the "ON MODE" button once will
display the previously set power level for 5 seconds; after this 5 second period, the
display will return to show the current operating power.
If Maximum power has been selected, adjust the
"+"
or button to the desired comfort tem­
perature, from 42 to 95°F (5 to 35°C). By pushing once the
"+"
or button the desired
temperature (shown on the right side of the display) will increase or decrease of 1 °F. Keep
pushbutton pressed to move through the temperature in fast mode.
correct time
set temperature