Iv. connecting other equipment – Bose Direct / Reflecting 901 Series 4 User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
IV. Connecting Other Equipment
A. TAPE RECORDERS
Since the Active Equalizer is connected to your integrated
amplifier, preamplifier, or receiver, where the tape recorder is
normally connected, extra jacks are provided on the equalizer
for the connection of a tape recorder. Refer to FIGURE 7 and
follow the next five steps carefully.
1. Turn all power off.
2. Connect the RIGHT channel TAPE IN jack on the equalizer
to the RIGHT or “B" channel OUTPUT jack on the tape
recorder.
3. Similarly, connect the LEFT channel TAPE IN jack on the
equalizer to the LEFT or “A” channel OUTPUT jack of the
tape recorder.
4. Connect the RIGHT channel TAPE OUT jack on the equal
izer to the RIGHT or “B" channel INPUT (or LINE IN) jack
of the recorder.
5. Similarly, connect the LEFT channel TAPE OUT jack on the
equalizer to the LEFT or “A” channel INPUT (or LINE IN)
jack on the recorder.
NOTE: IF YOUR CONTROL AMPLIFIER HAS TWO TAPE
MONITOR CIRCUITS. BE CERTAIN TO CONNECT YOUR
TAPE RECORDER TO THE BOSE ACTIVE EQUALIZER. NOT
TO THE UNUSED TAPE MONITOR ON YOUR RECEIVER.
Installation of the tape recorder is now complete. To play the
tape recorder, simply place the TAPE switch on the 901 Active
Equalizer in the MONITOR position (in).