Kenwood TK 3100 User Manual
Protalk™ vhf, Protalk™ uhf
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- INTRODUCTION
- FCC LICENSE INFORMATION
- MODELS COVERED BY THIS MANUAL
- NOTICES TO THE USER
- CONTENTS
- UNPACKING AND CHECKING EQUIPMENT
- PREPARATION
- GEniNG ACQUAINTED
- OPERATING BASICS
- CHANNEL FREQUENCY SELECTION
- QUIET TALK (QT)
- QT Tone Setup
- 4 Press the PTT switch to select the 10’s digit of the signalling number
- 5 Wait for 2 seconds to hear the beep pattern of the 10’s digit number you selected .
- 6 Press the PTT switch to select the 1’s digit of the signalling number
- 1 Wait for 2 seconds to hear the beep pattern of the Vs digit number you selected.
- 8 Press the Monitor key to complete the setting.
- QT Tone Setup
- CHANNEL SETTING CONFIRMATION
- TRANSCEIVER FUNCTIONS
- CHARGING THE NiCd BAHERY PACK
- OPTIONAL ACCESSORIES
- TROUBLESHOOTING GUIDE