Kenwood KAC-7200 - Manual (Page 3)

CONNECTION II you ruHstf whon me engine.
(he iKie noise tilt»N CN iOO lopuonall to the power
source tfC<i) of this unit.
* Wiiüfi SZ 2D is not bomij used, connect ttie power
su()ply as follows:
Precautions
Since Itio electrical consumption of th.s uml is larye. obiaining
powni source from wirings sucti as Ifiose of bviilt m cigarottti
liytiters will overload Itie winng of ibe cai
Make- Sure to eilhoi use SZ-20 loplional) or connect ttio
power source (red) to a position wiiti sufficient current
capacity such as the point iimmociiately next to the car's main
lusu, as stKjwri 1(1 tluj illiistiaiion above (Be sure ttial the tuso
IS pos.tioned between the battery and the unit)
Before starting to install the sot, make sure to remove the
negative ( -] terminal of Itie battery in order to prevent
shüilcircuHing.
When installation and wiring are completed, connect tbe
negative ( -1 terminal of the battery after confirming that
them are no enors
When a luse is blown out, check for any shortcircuiting
of coirls. and then replace it with a fuse having the
specified capacity