Kenwood DPC-41 - Manual (Page 9)

Listening through headphones
<Fig. 7> .
• Connect the headphone (optional) plug with the "PHONES" jack (use <j>3.b stereo mini plug).
Conduct the pull-in/out operation of the jack during Power is OFF.
• Adjust the volume with the VOLUME control.
Notes:-------------------------------------------------------------------------------------------------------------
• Keep the plug of headphone clean all the time.
Non-clean plug may cause noise.
• Avoid using the headphone when you drive a car and so on for traffic safety.
• Be careful not to fall asleep with the headphone on.
.
As a Compact Disc contains very little noise, a sudden loud sound could be output
if the VOLUME control is adjusted too high: this could cause serious damage to
your ears.
Playback through a home audio system
■ Playback using the "LINE OUT” output <Fig. 8>
• Power is supplied through the provided AC adaptor.
•
Connect the provided audio connection cord to "LINE OUT" of the main unit, then insert the
white plug into the outside-input terminal (AUX terminal) of amplifier or the left input terminal
of CD input terminals. Set the input selector of amplifier to "AUX" or "CD". When input is
to be made from the main unit to a tape deck, connect the cord to "LINE-IN" terminal.
• Set the "VOLUME" thumbscrew at scale 7 for volume adjustment made by the amplifier.
•
When the direct input from the main unit to a tape deck is to be made, adjust the volume
with volume-level adjuster (REC LEVEL) of the tape deck.
Caution:------------------------------------------------------------------------------------- —------------------
• Before making connections, be sure to turn the amplifier power off.
Do not connect the main unit to the PHONO terminal of the amplifier.
CD playback in an automobile
<Fig. 9>
■ Use in the car audio cassette adapter CAC-1 (optional)
• When the power source is taken from a cigar socket of a car, use the optional car battery
adaptor DC-C7. It allows you to enjoy listening to music for a long time without worrying about
the battery consumption.
• Insert the plug of car audio cassette adaptor CAC-1 (optional) into the "LINE OUT" terminal
of the main unit. Insert the CAC-1 to the car component deck, and turn the car component
deck into the PLAY mode.
• Set the "VOLUME" thumbscrew at scale 7 for volume adjustment made by the car cassette .
deck. -
Notes:--------------------------------------------------------------------------------------------------------------
• Since car battery adapters available in the market have different polarity and voltage, they
may result in troubles. (Be sure not to use a car battery adaptor other than the optional
DC-C7.)
• In case the unit is used in a car, install it taking the safety in consideration, so that it does
not interfere with the driving operations.
• The CAC-1 cannot be used with some car audio cassette models.
• Do not leave the unit in a closed automobile where the temperature is expected to be high.
• Place the unit on a soft place where automobile vibrations are not easily transmitted.
• If any sound skipping occurs due to vibrations, turn on the [HOLD] switch to reduce the sound
skipping.
DPC-41