Kenwood TS-130SE User Manual
Model ts-130se, Instruction manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
» «*
m
»#^**» ■•»«# « **■#-*• ni ~:
* »»«(:* 4>mMm^M * »■•'» sr^asc»
■i »
» ■: ■
»***»«. St
^ ^ y.
-f
/./^
S:
^ ^
»♦ttH
wiiS
i f ' /
i. ^ &&-w%-
,4.- '
y -
i;r ^.1..........
t-^ ♦ . .#/ ^1
,\/'Z/'/ ''"',i *''■
" r^ //
. nit> ^ ^ ‘
\A
* '< ^\Sf .y <"i ..
....... ^"'' '.
Model TS-130SE
INSTRUCTION MANUAL
i.#£%-iS3
Advertising
Table of contents
Document Outline
- INSTRUCTION MANUAL
- TS-130SE SPECIFICATIONS
- 1. SINGLE-CONVERSION SYSTEM USING PLL CIRCUITRY
- 2. BUILT-IN DIGITAL DISPLAY
- 3. BUILT-IN IF SHIFT CIRCUIT (Passband Tuning)
- 4. 3.5 ~ 29.7 MHz BAND
- 5. IMPROVED TWO SIGNAL CHARACTERISTICS
- 6. BUILT-IN RF ATTENUATOR
- 7. BUILT-IN SPEECH PROCESSOR
- 8. AUTOMATIC SSB MODE SWITCHING
- 9. COMPACT, LIGHTWEIGHT DESIGN
- 10. EASY OPERATION
- 11. ALL SOLID-STATE DESIGN
- 12. A FIXED CHANNELS
- 13. FULL RANGE OF AUXILIARY FUNCTIONS
- 14. SSB narrow filter YK-88SN
- 15. OPTIONAL CW FILTERS YK-88C AND YK-88CN
- 16. WIDE VARIETY OF OPTIONAL ACCESSORIES
- 2.1 INTERCONNECTION
- 2.2 ACCESSORIES
- 2.3 INSTALLATION
- SECTIONS. CONTROLS
- 3.1 FRONT PANEL 0 METER
- 0 DIGITAL DISPLAY
- 0 MODE SWITCH
- Front Panel
- 0 STANDBY SWITCH
- 0 MIC CONNECTOR
- (D PHONES JACK
- ® VOX (VOICE OPERATED TRANSMIT) SWITCH
- (D METER SWITCH
- ® MAIN TUNING CONTROL
- (0) RIT INDICATOR
- (Q) IF SHIFT CONTROL
- @ RIT CONTROL
- (3) CAR (CARRIER LEVEL) CONTROL
- (0) MIC (MICROPHONE GAIN) CONTROL
- (0) AF GAIN (AUDIO GAIN) CONTROL
- @ RF GAIN CONTROL
- (g) BAND SWITCH
- CAUTION: —
- (2) POWER SWITCH
- @ NB (NOISE BLANKER) SWITCH
- @ RF ATT (ATTENUATOR) SWITCH
- ® RIT SWITCH
- ® vox GAIN CONTROL
- (g) DELAY CONTROL
- (g) ANTI-VOX CONTROL
- NOTE:
- ® FIX INDICATOR
- (8) VFO INDICATOR
- 3.2 REAR PANEL
- 4.1 RECEPTION
- 4,2 TRANSMISSION (Fig. 4-4)
- TS-130SE
- 4.3 VOX OPERATION
- 4.4 SEMI-BREAK-IN OPERATION
- 4.5 OPERATION WITH A LINEAR AMPLIFIER
- 4.6 FIXED CHANNEL OPERATION (Fig. 4-6)
- 4.7 CW OPERATION (Fig. 4-8)
- 4.8 MOBILE OPERATION (Fig. 4-10)
- POWER CABLE
- 4.8.3. MOBILE ANTENNA
- (1) Antenna Installation
- NOTES;
- (2) Coaxial Cable Connection (Fig. 4-10)
- (3) Antenna Adjustment (Fig. 4-11)
- 4.8.4. NOISE REDUCTION
- (1) Antenna Location Selection
- (2) Antenna Matching
- Fig. 4-12 Matching Circuits
- (3) Bonding
- (4) Use Ignition Suppressor Cable or Suppressor Spark Plugs
- CAUTION: —
- (6) Battery Capacity
- 4.9 FIXED STATION OPERATION
- 4.10 DIGITAL DISPLAY CALIBRATION (Fig. 4-14)
- 4.11 ANALOG DIAL CALIBRATION
- (Fig. 4-15)
- 3.1 FRONT PANEL 0 METER
- SECTIONS. ADDITIONAL INFORMATION
- MEMO
- ■ Model PS-30 Regulated DC Power Supply
- ■ Model VFO-120
- ■ Model DFC-230
- ■ Model AT-130 Antenna Tuner
- ■ Model SP-120 External Speaker
- ■ HAM-CLOCK HC-10
- ■ MICROPHONE MC-60/N4
- ■ MICROPHONE MC-50
- ■ MICROPHONE MC-30S, MC-35S
- ■ HEADPHONE HS-6
- ■ DELUXE HEADPHONE HS-5
- ■ HEADPHONE HS-4
- m YK-88C AND YK-88CN CW CRYSTAL FILTERS
- ■ SSB NARROW FILTER YK-88SN
- INTERNAL VIEWS
- SCHEMATIC DIAGRAM
- TS-130SE SCHEM