Bose SE-5 - Manual (Page 6)

In Case You Have a Problem
If you hâve a problem connecting and using your S£-5 sys­
tem. try the procedures listed below. The majority ol prob­
lems usually occur in components other than the speakers.
Problem:
The lelt Stereo Targeting" array doesn't play or sounds
distorted.
Solution:
Turn oil the amplifier or recerver. Check lhewiringwhid|^
connects the Stereo '^rgeting array to the Acousiimass '
module, and the wiring v/hich connects the module to the
amplifier or receiver. II no visible problem is found, discon­
nect the vrires at the back ol the amplifier or receiver. Now
connect Ihe lelt wires from Ihe module to the right amplilier
terminals. Turn the balance control on the receiver or ampli­
lier complelety to the right, and turn the power on. If the lelt
Stereo Targeting array now works property, the left channel
of your amplifier or receiver is probably (Meclive.
CAUTION: Do not connect the other Stereo Targeting
array to the channel in question. If the amplifier or
receiver channel is defective, damage to your SE-5
system might occur.
CAUTION: Never conned a Stereo Targeting array
<//rec//ytoareceiver/amplifier'$speakerterminals.
The nght Stereo Targetingf ' array doesn’t play or
sounds distorted.
The whole SE-5 speaker system does not play or
sounds distorted.
Use Ihe same procedure as given for the lelt Stereo
Targeting array, but substitute the words "lett" lor "right" and
"right'for “left':
Turn off Ihe receiver or amplifier and disconnect the SE-6
system. Reconnect the SE-5 system to another receiver or
amplifier known to be working properly. If the SE-5 system
noiY works properly. Ihe problem is not in the SE 5 system.
Note: II this is the case, you should check all user accessi­
ble fuses on your receiver or amptilier (see Ihe appropriate
ovmer's guide for help). It the fuses blow again, have the
amplifier or receiver chedied by qualified personnel.
If trouble persists in your SE-5 ^slem. contact your author­
ized Bose"' dealer. The dealer wilt verity any detects and
arrange for service by an authorized service agency or by
the Bose factory. Bose Corporation will make every effort to
lemedy any problem within the terms ol the warranty at
minimum inconvenience to you.
Technical Information
Features
Acoustimass - speaker technology
Oirect/Reliecling - speaker design
Syncomcomputer quality assurance program
Automatic protection circuitry
Driver Complement
Two 6“ (15.2 cm) low-frequency drivers
Four 2.5" (6.4 cm) magnetically shielded, v/ide-range
drivers in Stereo Targeting' arr^s
Nominal impedance
6 ohms
Amplilier Power Requirements
(measured by lEC standard)
Minimum; 15 v/alls
Maximum; 100 waits
Finish
Acousiimass^' module; Scratch-resistant black satin
finish
Stereo Targeting' arrays; Black polymer finish
Dimensions
Acoustimass'- module; x 125/fe*W x 20yi6"D
(19.2x32.1 X 51.3 cm)
Stereo Targeting array; 8)4“H x 4 x 3yi6"D
(10.9 cm H X 12.3 cm W X 9 cm 0)
Weight
33 lb (15 kg), in shipping carton