Toshiba 79077075 - Manual (Page 44)

utners
Before Calling Service Personnel
Check the following guide for the possible cause of a problem before contacting service.
Symptoms and correction
Symptom Cause Correction Page
No power. • The power plug is disconnected. • Connect the power plug securely into the
wall outlet.
16
The DVD video player turned
off by itself.
• The automatic power off function turned
the unit off.
• Press the PLAY button. 21
No picture. • The TV is not set to receive DVD signal
output.
• Select the appropriate video input mode
on the TV so the picture from the DVD
video player appears on the TV screen.
20
• The video cable is not connected securely. • Connect the video cable securely into the
appropriate jacks.
16, 17
No sound. • The equipment connected with the audio
cable is not set to receive DVD signal
output.
• Select the correct input mode of the
audio receiver so you can listen to the
sound from the DVD video player.
20
• The audio cable is not connected securely. • Connect the audio cable securely into the
appropriate jacks.
16, 17
18, 19
• The audio receiver or TV is turned off. • Turn on the equipment connected with
the audio cable.
20
• The setting of output sound format is
incorrect.
• Select the proper audio setting. 33, 35
39
The playback picture has
occasional distortion. • The disc is dirty. • Eject the disc and clean it. 9
• It is in fast fonward or fast reverse
playback.
• Sometimes a small amount of picture
distortion may appear. This is not a
malfunction.
Brightness is unstable or
noises are present in the
playback pictures.
• The effect of copy protection. • Connect the DVD video player directly to
the TV. Avoid connecting the DVD video
player to a VCR orTV/VCR combination.
16
The DVD video player does
not start playback.
• No disc is inserted. • Insert a disc. 20
• An unplayable disc is inserted. • Insert a playable disc. (Check the disc
type and color system.)
10
• The disc is placed upside down. • Place the disc with the playback side
down.
20
• The disc is not placed within the guide. • Place the disc correctly inside the guide
on the disc tray.
20
• The disc is dirty. • Clean the disc. 9
• The parental lock function is set. • Cancel the parental lock function or
change the parental lock level.
35, 41
Playback does not follow the
course of the disc’s program.
• It is in the mode of repeat playback,
memory playback, etc.
• These operations may prevent a proper
progress of the contents.
—
Buttons do not work. • Power supply fluctuations or other
abnormalities such as static electricity may
interrupt correct operations.
• Turn the power on or off with the POWER
button. Or disconnect the power plug and
insert it into the wall outlet again.
The remote control does not
work properly. • The remote control is not pointed at the
remote sensor of the DVD video player.
• Point the remote control at the remote
sensor of the DVD video player.
15
• The remote control is too far from the DVD
video player.
• Operate the remote control within about
7 m.
15
• The batteries in the remote control are
exhausted.
• Replace the batteries with new ones. 15
44