KORG Concert Korg Digital Piano C-150 - Manual (Page 27)

Installing tfie Korg MIDI Driver into the Macintosh
Note; In order to use the Korg MIDI Driver, Apple MIDI Man­
ager and PatchBay must already be installed. Use the
Apple MIDI Manager and PatchBay that are included
with the MIDI application that you are using. They are
not included with the AG-002B,
When the Korg MIDI Driver is used, the ^'Modern
MIDI Out/Port settings"' dialog box allows you to
specify the MIDI channels and types of messages that
will be sent to the C-350. If you do not require this
function, you can simply use the Apple MIDI Driver
without using the Korg MIDI Driver. When using the
Apple MIDI Driver or when using a MIDI applica­
tion (sequencer) which does not use the Apple MIDI
Driver, refer to page 26 .
Copy the Korg MIDI Driver from the disk in­
cluded with the AG-002B into the system folder
of the start-up drive. 1.
é
Fiie Edit Itiew Esiiel Special
2. If the system folder contains the Apple MIDI
Driver, either delete it or move it to another
folder. Be careful not to delete or move the Apple
MIDI Manager.
*
The Korg MIDI Driver includes the functions of
the Apple MID! Driver.
3. From the Special menu, choose "Restart".
1, Korg MIDI Driver instaUation and setup
Setting up the Korg MIDI Driver (Macintosh)
1. Start up PatchBay.
If installation has been performed correctly, the
Korg MIDI Driver icon will appear in the PatchBay
window when PatchBay is started up, as shown be­
low. (The Modem/Printer port displays may be dif­
ferent, depending on your setup.)
Ttrno Poll MIDI In Port MIDI Out Port
Con reeled Pert
Modem Port
Printer Port
Pater |Bgg gg
Ü
2. In PatchBay, double-click the Korg MIDI Driver
icon.
A setup dialog box will appear.
KORG MIDI Driver Settings -
pM Ver l.O.B
1 About... i
Port Enabled: 0 □
interface Type: 1 MHz 1 1 MHz
Time Code In: none 'T } none -i
Time Code Out: none 1 none
FilterTime Code In: 0 0
Out port setting: 3E ih Out.. Ì
{
Si.inthCut..
1
Out port setting: MIDI Out... ) ]
(All Notes Off)
3. Check Port Enabled for the port to which the C-
350 is connected, and select (1 MHz] as the Inter­
face Type.
(Since the C-350 does not contain a Korg PC IF, do
not select [Korg PC IF].)
4. Click the [Out Port Setting] button.
The following dialog box will appear. Here you can
select the MIDI channels/messages that will be out­
put to each port. Only the channels/messages which
are checked will be output.
Modem MIDI Out Port setting
Eneùle MID! Ch, Enaùle MIDI Status
S2
E13
^4
0 6
07
08
09
0 to
0 1 1
0
12
0 13
0 14
0 15
0 16
0 Program Change
0 Control Change
0 Bank Select
0 Channel Pressure
0Po!y Key Pressure
0 Exclusive
Cancel )1
27